Ceiling Heating

The main objective of any heating system – creating a comfortable temperature, humidity conditions for human life at the lowest possible financial cost and minimal impact on the environment. Planning organizations in the calculation of the enlarged heating objects lay 100 watts per hour per square meter of heated area. In the construction of the heating system on film electric heaters (hereinafter PLEN) is necessary lay at least 130W per hour per square meter of heated area, but after leaving the premises (building) on the thermal regime, the latter will consume about 15Vt/chas per square meter on average during the season. Attention should be note that these indicators of energy consumption are possible under the following conditions: Time out of the building (room) for treatment typically ranges from 2 to 4 weeks; building (premises) must comply with snip 23-02-2003 "Thermal Protection buildings; ceiling height must not exceed 3.5 meters temperature, placed on the thermostat must not exceed +20 C; the building (room) should be provided with natural circulation of air (lack of drafts and open air vents). The level of the room temperature depends on several factors: its increasing influence of heat capacity of the heating system, the location of heating device and the intensity of other sources of income heat. For a fall – the thermophysical properties of the inner and outer fences. In the cold season in the main room loses heat through the exterior fence and, to some extent, through internal barriers that separate the premises from the adjacent, having a lower air temperature. . .